Hey @thegibson what's the best thing you use to keep the 3d prints from sticking to the plate? (Mines heated)

@dewb

A couple of ways... there are magnetic buildplates... the top layer peels off.

Painters tape is what most people use.

I usually just go with hairspray on glass, and use a tool to pop it off.

Follow

@thegibson @spacerog another friend was telling me that pla is affected by moisture over time and will start sticking to the bed. Going to buy some new pla and throw some silicone at it. Thanks for the protips

Sign in to participate in the conversation
hackers.town

A bunch of technomancers in the fediverse. Keep it fairly clean please. This arcology is for all who wash up upon it's digital shore.